WD30WC
Thermador WD30WC
What we most often repair on units like this
- Touch control that does not respond or beeps
- Drawer that stays cold even though the control lights up
- SoftClose action that has gone rough
- Proof mode holding the wrong temperature
- Stainless front scratched or misaligned after rail wear
- Power cord or outlet problems
With the WD30WC the drawer face is stainless steel, which means it is meant to sit visibly under a Thermador wall oven, speed oven or microwave rather than hide behind a wood panel. Its touch control sets one of three heat levels or Proof, and when a customer says the drawer has gone dead, the question is whether the panel or the heater is to blame.
We split the problem in two. A lit panel with no warmth points to the heater, the thermostat or the safety cutout inside the 2.2 cu. ft. cavity. A panel that does not light or respond needs a look at the control and its power supply. The drawer plugs into a plain 120 volt receptacle through an 84 inch cord.
On every visit we also test the telescopic rails and the SoftClose damper, since a full load of 27 plates presses on them. A thermometer in the cavity verifies High, Medium, Low and Proof settings. We give you the price in writing before ordering anything.
Key features
- Warming drawer in stainless steel with touch control
- 2.2 cu. ft. interior, measuring 7 11/16 x 21 7/8 x 20 1/4 inches
- 27 dinner plates up to 10 1/2 inches
- High, Medium and Low settings plus Proof mode
- SoftClose drawer on telescopic rails
- Pairs with a Thermador built-in wall oven, speed oven or microwave
- 120 V, 3-prong plug, 84 inch cord; 72 lb
The touch control lights up, but the drawer does not warm. Why?
The panel is only part of the story. The heater, thermostat or a thermal cutout may have failed. We test each one with a meter and then check the temperature in the drawer.
Is it normal for the drawer to feel only warm, not hot?
Yes. A warming drawer holds food at serving temperature rather than cooking it. High is the hottest setting. If High barely warms the cavity, we test the heater.
Can I stack a heavy load of dishes in it?
The drawer is designed for 27 plates of up to 10 1/2 inches. Loading far beyond that strains the rails and SoftClose damper, which is a common reason for rough movement.
Schedule service for your WD30WC
Request a visit online in about a minute or phone our coordinators. Close-in neighborhoods often get same-day service; the outer counties usually get the next day across Houston.