Booking today · Houston arrival windows 8–10 · 10–12 · 12–2 · 2–4 Thermador repair specialists, independent · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 597-4873 Book an Appointment
Model library · Thermador Ventilation Hood

VCIN54GWS

Thermador VCIN54GWS

What we most often repair on units like this

  1. Sag or vibration in a 51 3/4" body that is only partly supported
  2. Damper sticking so the blower strains
  3. Several baffle filters out of line
  4. LED sections failing across the long insert
  5. Wi-Fi link missing
  6. Duct restriction on a long run

This 54″ insert is for kitchens built around a range or cooktop-plus-griddle combination that takes up almost half of a wall. The body is 51 3/4″ long, so unlike the smaller models, support and flex are real considerations, and a hood that is not fixed evenly can rattle at certain speeds.

We begin by looking at how the VCIN54GWS is supported and whether the surround contacts it. Then we examine the damper and duct, because a long, wide insert still depends on a single duct path. Baffle filters across the width are checked one at a time, and the LED line is tested for dark sections.

The four speeds, quiet low setting, reminder and Wi-Fi are run last. VCIN54GWT is named as a successor, and we verify the label first. Any repair is quoted in writing before we start, and carries a 30-day warranty.

Key features

  • 54"-wide custom insert, finished in stainless steel
  • Wall-mounted, spans 51 3/4" wide and 22" deep at a height of 12 13/16"
  • Ducted venting with washable baffle filters in stainless steel
  • Touch panel selects 4 fan speeds
  • Damper and clean filter reminders
  • Delay shut off; vivid LED lighting
  • Powerfully Quiet System; Wi-Fi and Hood Sync
  • Blends into cabinetry; VCIN54GWT is the listed successor
→Codes

Codes this model may display

VCIN54GWSVCIN54GWS questions
My 54" insert rattles at one speed only. Why?

A resonance at a given speed usually points to a loose mount, a surround touching the body or an unbalanced wheel. We check each and correct the one we find.

How many baffle filters are in this hood?

The number depends on the unit configuration. We check each filter you have and make sure it is seated and clean before moving to the blower.

Do you replace only the LED section that failed?

Where the design allows, yes. We find the section or connector that has failed and quote that part in writing. You get the cost before approving it, so nothing is a surprise.

Request service

Schedule service for your VCIN54GWS

Request a visit online in about a minute or phone our coordinators. Close-in neighborhoods often see a same-day slot; the outer counties usually get the next day across Houston.