Why it happens here
Houston air carries a lot of moisture for most of the year. When that warm, damp air touches a cooler surface, water droplets form. A refrigerator door, its frame and the gap between the doors are all slightly cooler than the room, so on very humid days a little moisture can appear on the outside, especially after the doors were opened often or the home’s air conditioning was turned off.
Care that reduces it
- Keep indoor humidity in check by running the air conditioning steadily, not in short bursts.
- Wipe the gaskets with warm, soapy water every few weeks and dry them well.
- Close the doors firmly and avoid holding them open while deciding what to cook.
- Do not block the grille at the top or base of the unit.
- Check that the refrigerator is level so the doors swing shut and seal on their own.
What a seal test tells you
Close the door on a strip of paper at several points around the frame. It should hold with mild resistance everywhere. A spot where the paper slides out freely means warm air is getting in, and that is where condensation and frost will form.
When it is more than humidity
Many built-in refrigerators have small heaters near the door frame or between the doors to keep moisture from forming. If one side is always wet while the other stays dry, water drips onto the floor, or frost forms inside along a door edge, the gasket or that heater may need attention. Persistent moisture can also damage cabinetry and flooring. We check seals and heaters as part of our refrigeration work; see our refrigerator repair page.
Book whenever the moisture will not go away. We put the cost in writing before starting, and labor is covered for 30 days.