Thermador VCI3B36ZS
Despite the 36 in its model number, the VCI3B36ZS body is 32 1/2″ wide, which is why it is built into a surround, not hung over the stove like a canopy. That 4-inch gap on each side matters when a new range is installed and the hood does not fully cover the width of the cooktop.
We look at where it sits relative to the cooktop first, then check whether the blower housing touches the cabinet, which causes the humming owners often describe as a hood problem. The duct is the next stop, since there is no damper and any cold air will come straight down it.
Four fan speeds, delay shut off and Wi-Fi with Hood Sync are tested next. Since the lighting is a low-consumption type, we check it at the lamp connection and not just the switch. Parts are quoted in writing before we proceed.
It depends on how it was installed and what you cook. If capture is poor at the outer burners, we assess duct and fan first and talk through what could improve it.
Usually the blower housing is touching the cabinet or the wheel has built-up grease. We isolate the housing and clean the wheel. Hum rarely means the motor itself.
Yes. If the hood lost its connection, we repeat the pairing and test whether Hood Sync reacts to the cooktop. The whole check takes a short visit and costs nothing extra to try.
Request a visit online in about a minute or phone our coordinators. Close-in neighborhoods often see a same-day slot; the outer counties usually get the next day across Houston.