Thermador POD301 and POD302 Oven E + number: Display Code With Beeping

What E + number means

On the older Thermador POD301 and POD302 built-in ovens, an E followed by a number with beeping is an error code, as described in the older Use and Care manual. The manual gives no per-number list. It says to press the plus and minus keys together to stop the beeping and clear the display, reset the oven if needed, and record the code if it stays.

Usual causes of E + number

Error code shown by the control; the manual gives no per-number meaning

✓ A safe check worth trying

1. Press + and - together to stop the beeping and clear the display. 2. Reset the oven if necessary. 3. If the code remains, write down the whole code. 4. Cancel the oven and call us with the code and the model number.

! Why you should stop here

Without a code table, only on-site testing finds the cause
Resets only mask a repeating problem
A written record of the number speeds the visit

Taking off a panel yourself does not by default void a manufacturer warranty, yet it can lead to accidental damage, and some manufacturers attach their own service terms. Read your warranty paperwork, or ask us, before you decide.

→Same appliance

More Oven codes

F12F12 on a Legacy Thermador C-Series Oven: Vcc Lift-Off on the Power/Relay Board F50Older C/CM-Series Thermador Wall Oven F50: Upper Door Signal Shorted Low F1Older SC/SM-Series Thermador Wall Oven F1: Element Supervisor Enabled F13Thermador C/CM/CJ Wall Oven Code F13: Power Board Not Calibrated, Air Switch Check F51F51 on an Older Thermador Wall Oven (C/CM-Series): Upper Door Stuck Unlocked F2F2 on an Older Thermador Wall Oven (SC, SCD, SM, SMW): Temperature or Door Light During Self-Clean F14Thermador Older C-Series Oven, Control Display EEPROM Error F14 F52Thermador Wall Oven F52 in the Legacy C/CM Family: Upper Door Reads Locked and Open

E + numberE + number questions

Which keys stop the beeping?

The manual says to press the plus and minus keys together. That silences the beeper and clears the display so you can see whether the code returns.

Why does the number matter?

Even without a published list, the exact number helps a technician narrow down which circuit reported trouble. Record it before you reset. We read the circuit before suggesting any replacement.

Can I keep cooking after a reset?

If nothing returns, careful use is reasonable. If the code comes back, cancel the oven and book a visit rather than cook through it. Photos of the display are welcome when you book.