Thermador Wall Oven F70 in the Legacy C/CM Family: Lower Meat Probe Shorted
F70 shows on older Thermador C, CM and CJ302 ovens when the lower oven meat probe circuit reads as shorted. This is a low-severity code: it points to the probe wiring rather than the heating system.…
- Code
- F70
- Appliance
- Oven
- Brand
- Thermador
- Warranty
- 30-day workmanship
What F70 means
F70 shows on older Thermador C, CM and CJ302 ovens when the lower oven meat probe circuit reads as shorted. This is a low-severity code: it points to the probe wiring rather than the heating system. If you use the probe, check it first. If you never plug it in, the short may be inside the oven wiring or on the control display board.
Usual causes of F70
- Short in the meat probe wiring
- Control display board, if the code persists after the wiring is checked
1. Stop the oven and let the cavity cool. 2. If a probe is plugged in, unplug it and look at the cable for damage. 3. Reset with OFF or the breaker for 3 minutes. 4. If F70 returns with no probe attached, note it and call us.
- The probe jack wiring runs behind the cavity wall
- Board replacement should follow a wiring test
- A damaged probe cable can be mistaken for a board problem
Technical reference
- Code
- F70
- Appliance
- Thermador oven
- Maker documentation
- Thermador owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Thermador.
More Oven codes
Do I need the probe to cook?
No. You can bake without it. If F70 blocks normal cooking, a technician should look at the probe circuit so the oven works again. Work on your oven comes with a 30-day workmanship warranty.
Could my probe be bad?
Yes, a crushed or kinked probe cable can cause a short. Trying a reset with the probe unplugged is a safe first step. Keep the data plate details nearby when you phone.
Why would the display board be involved?
The probe jack connects to the display board header. If wiring checks fine and F70 stays, the manual says that board is the next item to replace.
Not sure about F70?
Our technician checks it in your home and hands you a written price before touching anything.