Legacy Thermador Cooktop F2 for CIT365DS and CIT304E Induction: Element Too Hot (Older Generation)
Seeing F2 on a CIT365DS or CIT304E induction cooktop means the element got too hot and turned itself off. This is the older generation's reading; on current Thermador induction cooktops F2 is an overheated-electronics message instead.…
- Code
- F2
- Appliance
- Cooktop
- Brand
- Thermador
- Warranty
- 30-day workmanship
What F2 means
Seeing F2 on a CIT365DS or CIT304E induction cooktop means the element got too hot and turned itself off. This is the older generation's reading; on current Thermador induction cooktops F2 is an overheated-electronics message instead. The shut-off is protective, so once the surface cools and you touch a key to acknowledge the display, normal cooking is usually available again.
Usual causes of F2
- Pan boiled dry or run empty on the element
- Extended high-power cooking heating the element
- Element still hot when the cooktop was restarted
1. Take the pans off the cooktop. 2. Wait until the element has cooled. 3. Touch a key to acknowledge the display so F2 clears. 4. If F2 keeps returning, leave the cooktop off and note how long you cooked before it appeared.
- A heat-protection circuit that trips again and again needs testing under power.
- Sensor and board checks on these older units require meters.
- Written price first, with parts confirmed by model number.
Technical reference
- Code
- F2
- Appliance
- Thermador cooktop
- Maker documentation
- Thermador owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Thermador.
More Cooktop codes
Why does F2 show up when nothing seems hot?
The surface can feel fine while the element sensor still reads high. Wait longer and try again. If F2 appears on a cold cooktop, the sensor or board needs inspection.
Is F2 on CIT365DS the same as on a current Thermador induction cooktop?
No. Current cooktops use F2 for overheated electronics, while this older table says the element is too hot. Match any code to your model before following advice.
Do I have to acknowledge the display?
Yes. The manual says F2 clears when you touch a key after the element has cooled. If the display won't clear even after cooling, call for service.
Not sure about F2?
Our technician checks it in your home and hands you a written price before touching anything.