Thermador Oven F40 on Older C-Series Models: Upper Meat Probe Shorted
F40 on an older Thermador C, CM or CJ oven says the upper oven's meat probe circuit reads as shorted. The service document points at a short in the probe wiring and says to check header…
- Code
- F40
- Appliance
- Oven
- Brand
- Thermador
- Warranty
- 30-day workmanship
What F40 means
F40 on an older Thermador C, CM or CJ oven says the upper oven's meat probe circuit reads as shorted. The service document points at a short in the probe wiring and says to check header P2 on the control display board and make sure the probe wire is not pinched. It is rated low severity, since normal baking without the probe may be unaffected. Newer Thermador ovens can use F40 differently.
Usual causes of F40
- Short circuit in the meat probe wiring
- Probe wire pinched, for example in the oven door or jack area
- Control display board, replaced if the code persists
1. Stop using the meat probe and leave it out of the oven. 2. Switch the oven off at OFF or the breaker and wait three minutes. 3. Restore power and bake without the probe. 4. If F40 returns, note whether it appears with or without a probe inserted, and call us.
- The probe, its jack and header P2 are separate suspects
- A pinched wire can look fine from outside
- We quote in writing first, with legacy parts confirmed by model number
Technical reference
- Code
- F40
- Appliance
- Thermador oven
- Maker documentation
- Thermador owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Thermador.
More Oven codes
Does F40 stop the oven from baking?
It is rated low severity because the probe is an accessory circuit. Many owners can bake normally without it, but we still recommend a check if the code returns or other trouble appears.
Is it the probe or the oven?
Either can cause it. The manual lists wiring, header P2 and the display board. Telling us whether F40 appears with the probe removed helps us narrow it down.
Can I buy a replacement probe myself?
A new probe may help only if the old one was the problem. We prefer to test first, since a pinched wire or board input could leave F40 on the display.
Not sure about F40?
Our technician checks it in your home and hands you a written price before touching anything.