Booking today · Houston arrival windows 8–10 · 10–12 · 12–2 · 2–4 Thermador repair specialists, independent · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 597-4873 Book an Appointment
Model library · Thermador Cooktop

SGSXP305TS

Thermador SGSXP305TS

What we most often repair on units like this

  1. Gas odor means shutting the valve first, then looking at a pedestal or ExtraLow burner
  2. Pedestal burners are not sealed flush to the top, so an unreliable ignition calls for a look under the QuickClean Base for spill residue
  3. A simmer that will not stay low usually reflects a worn knob or valve on that burner, not supply pressure

At the top of Thermador’s 30-inch gas cooktop lineup sits the SGSXP305TS, which brings two separate burner designs onto one surface. Five pedestal burners, with a QuickClean Base under each for easier wiping, deliver 54,000 BTU on natural gas and an 18,000 BTU middle burner, while two ExtraLow burners cover the gentle end.

Having two systems side by side makes the first question on a visit simple: which one is acting up? Pedestal burners that sputter tend to have spill residue or corrosion under the raised base. An ExtraLow burner that won’t hold its simmer is almost always a problem in that burner’s own knob and valve assembly, far from the gas line.

Isolating the affected burner type early saves time and keeps the repair narrow, so we compare a misbehaving burner against a healthy neighbor of the same kind before deciding what to open.

Key features

  • 30-inch gas cooktop at the top of the line, five Pedestal Star Burners plus ExtraLow
  • Gas ratings: 54,000 BTU total on natural gas, 45,200 BTU on LP
  • Middle burner rated 18,000 BTU
  • QuickClean Base pedestal burners together with two ExtraLow simmer burners
  • Offers both automatic relighting and very low simmer control
→Codes

Codes this model may display

SGSXP305TSSGSXP305TS questions
Why does one burner type misbehave while the other works?

The two designs fail differently. Pedestal burners suffer from residue and corrosion beneath the raised base, while ExtraLow burners suffer from knob and valve wear. Comparing like with like shows which system is involved.

What would corrosion under a pedestal burner look like?

You may notice crusty discoloration or green-white deposits around the igniter and base, along with sparking that is weak or intermittent. We clean it, and replace the igniter if the damage is real.

Is the gas line to blame when a simmer fails?

Seldom. When the other burners hold a steady flame, the supply is fine, so the cause nearly always sits in the specific ExtraLow control, where we test the knob, valve stem and burner.

Request service

Schedule service for your SGSXP305TS

Request a visit online in about a minute or phone our coordinators. Close-in neighborhoods often see a same-day slot; the outer counties usually get the next day across Houston.