Thermador Dishwasher E0100: Trouble in the Heat Pump Motor Circuit

What E0100 means

An unexpected stop, then E0100 on the display. Thermador documents this code as a problem in the heat pump motor circuit. The control tried to power the motor that drives the heat pump and did not get the response it needed, so it ended the cycle instead of running on with damaged hardware. The cycle ends early because continuing with an unresponsive motor could damage other parts.

Usual causes of E0100

A heat pump motor that has failed
A wiring or circuit problem on the way to that motor

✓ A safe check worth trying

1. Switch off the breaker feeding the dishwasher. 2. Count to thirty. 3. Switch the breaker back on and wait for the display to start up. 4. Begin a short cycle and see whether E0100 reappears. This breaker reset is Thermador's first recommended step for this code.

! Why you should stop here

When a breaker reset leaves the code in place, the motor circuit needs to be measured by a technician.
Wiring and motor checks involve line-voltage parts that should only be touched with the power isolated.

Taking off a panel yourself does not by default void a manufacturer warranty, yet it can lead to accidental damage, and some manufacturers attach their own service terms. Read your warranty paperwork, or ask us, before you decide.

→Same appliance

More Dishwasher codes

E3300Thermador Dishwasher E3300: Intake Blocked or Absent E3400Thermador Dishwasher E3400 and Water That Keeps Running In E6102Thermador Dishwasher E6102, Draining Trouble With Easy Culprits E6103Thermador Dishwasher E6103 When Nothing Drains After Installation E9240Thermador Dishwasher E9240: Water Will Not Leave the Tub E9210Thermador Dishwasher E9210 Flags a Bottom Spray Arm That Will Not Turn SAnlThermador Dishwasher "SAnl" Message: Sanitize Finished E:07Thermador Dishwasher E:07: Dishes Covering the Intake Opening

E0100E0100 questions

Is resetting the breaker safe to try?

Yes, it is the first step Thermador itself recommends for this code. Do it at the panel, with the dishwasher idle, and avoid opening any part of the machine.

What if E0100 returns after the reset?

Then the motor or its wiring is the likely culprit. Stop running cycles, write down the code, and let us test the circuit before any part is ordered.

Does this affect drying?

It could, because the heat pump drives both heating and drying. The code itself concerns the motor circuit, but a weak heat pump usually shows as damp dishes as well.