Thermador Dishwasher E9001: House Power Too Low at the Unit

What E9001 means

The dishwasher misbehaves or won't start, and E9001 sits on the display. Thermador describes it as incoming household power that is too weak by the time it reaches the unit. The control measures what arrives, finds it short of what it needs to run, and holds back instead of operating on weak power. Measuring that supply is a job for an electrician.

Usual causes of E9001

A shortcoming in the home's electrical supply
A circuit sized too small for the dishwasher's rated load

✓ A safe check worth trying

1. Switch the dishwasher's breaker off, pause briefly and switch it on again. 2. Notice whether lights on the same circuit dim when the dishwasher tries to start. 3. Unplug or turn off other loads sharing that circuit. 4. If E9001 persists, ask an electrician to measure the incoming voltage.

! Why you should stop here

Verifying incoming voltage takes an electrician, which is outside any appliance-side repair.
New dishwasher parts will not help if the circuit is the one delivering low power.

Taking off a panel yourself does not by default void a manufacturer warranty, yet it can lead to accidental damage, and some manufacturers attach their own service terms. Read your warranty paperwork, or ask us, before you decide.

→Same appliance

More Dishwasher codes

E9240Thermador Dishwasher E9240: Water Will Not Leave the Tub E9210Thermador Dishwasher E9210 Flags a Bottom Spray Arm That Will Not Turn SAnlThermador Dishwasher "SAnl" Message: Sanitize Finished E:07Thermador Dishwasher E:07: Dishes Covering the Intake Opening All LEDs light up or flashThermador Dishwasher "All LEDs light up or flash": Update or Reset E3100Thermador Dishwasher E3100 Trips Leak Protection Over Water in the Base Tray E3200Thermador Dishwasher E3200: Fill Falls Short of the Level the Board Wants E3300Thermador Dishwasher E3300: Intake Blocked or Absent

E9001E9001 questions

Is E9001 linked to E27?

They describe the same low-supply situation under two control platforms, so the advice for either is similar. Having the code written down helps us prepare.

Why might a circuit be too small?

The wiring may be rated lower than the load, or other appliances may share it. An electrician can check the rating and what else is connected before making a recommendation.

Will you check the voltage yourselves?

We test the dishwasher side, but changes to household wiring belong to an electrician. Should the supply turn out to be the cause, we say so plainly and avoid selling an unneeded part.