Thermador CT/CMT Oven E2 (Dreefs Control): Cook or Clean Temperature Runaway
If E2 shows up on an older Thermador CT or CMT oven with the Dreefs control, the oven believes it overheated: above 635 F while cooking, or 32 F past target during a clean cycle. A…
- Code
- E2
- Appliance
- Oven
- Brand
- Thermador
- Warranty
- 30-day workmanship
What E2 means
If E2 shows up on an older Thermador CT or CMT oven with the Dreefs control, the oven believes it overheated: above 635 F while cooking, or 32 F past target during a clean cycle. A second page of the service document gives 625 F and 890 F for the same code and points to the sensor or board. The control turns the heat and microwave off, and the message clears once the cavity cools below the runaway point with the selector OFF.
Usual causes of E2
- Temperature sensor reading wrong, which the document lists first
- Control board misreading a good sensor or failing to cut heat normally
- Heating element or relay staying energized
1. Set the selector knob to OFF; a slight counterclockwise tweak should end the flashing and beeping. 2. Leave the door closed and let the oven cool fully; do not open it to speed things up. 3. If E2 stays with the selector OFF, switch off the oven's power at the breaker and call us. 4. Skip self-clean until it has been inspected.
- A true overheat is a safety matter, so repeated restarts are not a test worth running
- The sensor and board are checked with meters while the oven is isolated from power
- We give a written price before any part is ordered or installed
Technical reference
- Code
- E2
- Appliance
- Thermador oven
- Maker documentation
- Thermador owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Thermador.
More Oven codes
How long until E2 goes away?
Per the manual it clears when the oven temperature drops below the runaway temperature with the selector OFF. Exact time depends on how hot the cavity was, so wait until it is comfortable to be near.
Did my oven actually reach 635 F?
Not necessarily. The document names the sensor or control board, so a bad sensor can report a runaway that never happened. A technician compares the reading with a real thermometer before deciding what to replace.
Should I use the oven in the meantime?
We advise against it. The control already shut heat off once for safety, and running again before inspection risks the same shutdown or real overheating. Call us and we will schedule a look.
Is E2 still showing?
Our technician checks it in your home and hands you a written price before touching anything.