Thermador Wall Oven F3 in the Legacy SC/SM Family: Open Oven Sensor
When F3 flashes on an older Thermador SC, SCD, SM or SMW oven, the control sees an open oven sensor: the circuit is broken or the plug has worked loose. With no temperature reading, the oven…
- Code
- F3
- Appliance
- Oven
- Brand
- Thermador
- Warranty
- 30-day workmanship
What F3 means
When F3 flashes on an older Thermador SC, SCD, SM or SMW oven, the control sees an open oven sensor: the circuit is broken or the plug has worked loose. With no temperature reading, the oven will not run. The service document gives the sensor a target of about 1050 ohms at room temperature and asks that the sensor plug be fully seated.
Usual causes of F3
- Open sensor or open circuit in the sensor wiring
- Sensor plug at the molex connector not fully seated
- Sensor that does not measure about 1050 ohms at room temperature
1. Stop using the oven until the cavity has cooled. 2. Turn power off at the breaker for 3 minutes, then back on. 3. If F3 flashes again, jot down the code and the model number. 4. Do not reach behind the oven to push plugs. Call us.
- Plug access is behind panels on a built-in oven
- Open circuits need resistance testing, not eyeballing
- A loose plug can look like a failed sensor
Technical reference
- Code
- F3
- Appliance
- Thermador oven
- Maker documentation
- Thermador owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Thermador.
More Oven codes
What does open mean here?
Open means the electrical loop through the sensor is broken. The control reads no signal at all, so it cannot tell the oven temperature and refuses to heat.
Could it just be a loose plug?
Possibly. The manual asks to confirm the sensor plug is seated, but the plug sits behind the oven, so that check is ours. We would rather confirm than promise from a table.
Does F3 mean a new oven?
Not on its own. A sensor or connection fix is the usual route, and we quote it in writing before any work. Only the parts that test bad go on the quote.
Is F3 still showing?
Our technician checks it in your home and hands you a written price before touching anything.